Abstract
New ferroelectrets were developed on the basis of foams from cyclo-olefin polymers and copolymers. The results obtained on the cyclo-olefin polymer foam demonstrate a significant improvement of the service temperature for ferroelectret transducer materials. Suitable compounding and preparation led to cyclo-olefin ferroelectrets with an electromechanical activity of around 15 pC/N, which is thermally stable at least up to 110degC. The properties in sensor and actuator applications are strongly dependent on the processing parameters related to film-making, sensor and actuator preparation, gas content and electric charging. The processing window for the film stretching was very narrow compared to the earlier developed polypropylene ferroelectrets. The film porosity, softness and thus the electromechanical activity are adjusted by gas-diffusion expansion. The activity of the electromechanically operating sensors and actuators was increased by stacking several layers of cellular cyclo-olefin film. For applications such as flat loudspeakers, the foamed films are tuned by tensioning them on a support frame. Correct tensioning was essential also for reducing the distortion levels
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callMore From: IEEE Transactions on Dielectrics and Electrical Insulation
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
