Novel ground microgravity experiment system for a spacecraft-manipulator system based on suspension and air-bearing

Abstract

With the development of aerospace technology, the on-orbit activities of large spacecraft are increasing day by day, and accordingly the amount of space debris is increasing. Therefore, a large spacecraft-manipulator system is needed to perform on-orbit service, such as, assembling large spacecraft and removing space debris. Before launching, the trajectory optimization and control algorithm of the spacecraft-manipulator system have to be verified on the ground microgravity experiment system since the complex systems are prone to failure. In this study, a ground microgravity experiment system based on suspension and air-bearing is proposed to provide a long-term and stable microgravity environment for the large spacecraft-manipulator system. A suspension gravity compensation system with multiple suspensions is designed for the redundant space manipulator that moves in three dimensions, and a suspension tracking smooth sliding mode control algorithm based on hierarchical control is presented. Then, the coupling-reduction strategy based on equivalent spring-mass is presented to reduce the electromechanical coupling of the suspension gravity compensation system and the space manipulator. For the roll and pitch motion of the large-mass/inertia spacecraft, the target spacecraft simulator with a 2-degree-of-freedom rotating mechanism is designed. Some air-bearings are installed on the base of the chaser spacecraft simulator and target spacecraft simulator, which produce an air gap to enable the frictionless plane motion of the spacecraft. Finally, the target spacecraft simulator transposition experiment was carried out. The results show that the residual torque of the space manipulator is very small, and the ground microgravity experiment system compensates the gravity of the spacecraft-manipulator system with high precision.