Novel chalcone-based aromatic polyamides: synthesis, characterization, and properties

Abstract

Two novel diacid-based monomers have been synthesized by anchoring a benzylideneacetophenone (chalcone) moiety through an amide or ester bridge at the fifth position of the isophthalic acid ring. Two series of new polyamides bearing chalcone side chains were prepared by direct polycondensation reaction of the aforementioned dicarboxylic acids and various aromatic diamines in N-methyl-2-pyrrolidinone, using triphenyl phosphite and pyridine as condensing agents. Their molecular structure and the basic properties were investigated by nuclear magnetic resonance, Fourier-transform IR and UV–vis spectroscopy, differential scanning calorimetry, thermogravimetric analysis, and wide-angle X-ray diffraction. The inherent viscosity, molecular weights measurements (by gel permeation chromatography), water uptake, and solubility tests completed the research study. Introduction of the rigid and bulky chalcone units into the polymer side chains improved remarkably the solubility of the aromatic polyamides, endowed them with an amorphous nature, good thermal stability, and photosensitivity. The resulting polymers were obtained in good yields, inherent viscosities varied between 0.49 and 0.86 dL/g, and their relative high molecular weights conferred them film-forming properties. They were soluble in amide-type polar solvents, such as N,N-dimethylformamide, dimethyl sulfoxide, N,N-dimethylacetamide, and N-methyl-2-pyrrolidone. These polyamides had glass transition temperatures between 219 and 264 °C, and 10% weight loss temperatures in the range of 394–436 °C and around 50% residue at 700 °C in nitrogen atmosphere. The polyamides underwent a [2 + 2] photocycloaddition reaction upon UV light irradiation both in solution and film state in the absence of a photoinitiator or photosensitizer. The polymer films became insoluble in solvents as a result of the crosslinking .