Nopadiene: A Pinene-Derived Cyclic Diene as a Styrene Substitute for Fully Biobased Thermoplastic Elastomers.

Abstract

The bicyclic 1,2-substituted, 1,3-diene monomer nopadiene (1R,5S)-2-ethenyl-6,6-dimethylbicyclo[3.1.1]hept-2-ene was successfully polymerized by anionic and catalytic polymerization. Nopadiene is produced either through a facile one-step synthesis from myrtenal via Wittig-olefination or via a scalable two-step reaction from nopol (10-hydroxymethylene-2-pinene). Both terpenoids originate from the renewable β-pinene. The living anionic polymerization of nopadiene in apolar and polar solvents at 25 °C using organolithium initiators resulted in homopolymers with well-controlled molar masses in the range of 5.6-103.4 kg·mol-1 (SEC, PS calibration) and low dispersities (Đ) between 1.06 and 1.18. By means of catalytic polymerization with Me4CpSi(Me)2NtBuTiCl2 and (Flu)(Pyr)CH2Lu(CH2TMS)2(THF), the 1,4 and 3,4- microstructures of nopadiene are accessible in excellent selectivity. In pronounced contrast to other 1,3-dienes, the rigid polymers of the sterically demanding nopadiene showed an elevated glass temperature, Tg,∞ = 160 °C (in the limit of very high molar mass, Mn). ABA triblock copolymers with a central polymyrcene block and myrcene content of 60-75 mol %, with molar masses of 100-200 kg/mol were prepared by living anionic polymerization of the pinene-derivable monomers nopadiene and myrcene. This diene copolymerization resulted in thermoplastic elastomers displaying nanophase separation at different molar ratios (DSC, SAXS) and an upper service temperature about 30 K higher than that for traditional petroleum-derived styrenic thermoplastic elastomers due to the high glass temperature of polynopadiene. The materials showed good thermal stability at elevated temperatures under nitrogen (TGA), promising tensile strength and ultimate elongation of up to 1600%.