Abstract
While CMOS single-photon avalanche diode (SPAD) technology has steadily advanced, improving noise, timing resolution, and sensitivity, spatial resolution has been increasing as well. The increase in the number of pixels has made a comprehensive analysis of nonuniformity and its effects meaningful, allowing a more accurate comparison of SPAD imagers with other high-end scientific imagers, such as electron multiplying charge-coupled device and scientific CMOS. A comprehensive nonuniformity analysis was conducted on a 512 × 128 pixel gated SPAD imager, where dark noise, afterpulsing, crosstalk, signal response, and shot noise were measured. This analysis has led to a variety of postprocessing algorithms to improve the linearity of the response as for example required by ground state depletion microscopy-based superresolution microscopy and other techniques. We derived a new correction formula for the count rate applicable to 1-b SPAD imagers, and we measured a significant improvement of photon detection efficiency using microlenses. These techniques were used to validate the suitability of the imager in fluorescence microscopy examples.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.