Nonsmooth Reduced Interface Models and Their Use in Co-Simulation of Mechanical Systems

Abstract

Abstract In a co-simulation setup, the entire system is decomposed into a collection of individual subsystems that are interfaced together, with each subsystem being modeled and integrated separately according to its own requirements. To maintain the interconnectivity and consolidation of the primary system, these subsystems must communicate with each other through the interface and transfer certain information at the end points of a defined time interval termed macro time step. Inside the macro time step, the evolution of the interface variables has to be approximated as information about them will only be available again at the end of the step. In real-time simulations, the size of the macro time step and the accuracy of the approximated interface variables are critical factors; if the interface variables are approximated accurately, the size of the macro time step can be kept large enough to provide interactive rates without loss of accuracy and stability. This work focuses on systems where unilateral contact interactions are important and proposes reduced interface model concepts for such nonsmooth systems. The use of the proposed reduced interface model (RIM) is demonstrated in co-simulation to provide model-based approximation of the interface variables. The advantages of the proposed method are demonstrated through two representative case studies.