Abstract

To handle the fast-growing demand for high data rate applications, the capacity of cellular networks should be reinforced. However, the available radio resources in cellular networks are scarce, and their formulation is expensive. The state-of-the art solution to this problem is a new local networking technology known as the device-to-device (D2D) communication. D2D communications have great capability in achieving outstanding performance by reusing the existing uplink cellular channel resources. In D2D communication, two devices in close proximity can communicate directly without traversing data traffic through the evolved-NodeB (eNB). This results in a reduced traffic load to the eNB, reduced end-to-end delay, and improved spectral efficiency and system performance. However, enabling D2D communication in an LTE-Advanced (LTE-A) cellular network causes severe interference to traditional cellular users and D2D pairs. To maintain the quality of service (QoS) of the cellular users and D2D pairs and reduce the interference, we propose a distance-based resource allocation and power control scheme using fractional frequency reuse (FFR) technique. We calculate the system outage probability, total throughput and spectrum efficiency for both cellular users and D2D pairs in terms of their signal-to-interference-plus-noise ratio (SINR). Our simulation results show that the proposed scheme reduces interference significantly and improves system performance compared to the random resource allocation (RRA) and resource allocation (RA) without sectorization scheme.

Highlights

  • Device-to-device (D2D) communication underlaying long term evolution-advanced (LTE-A)cellular networks is proposed as an up-and-coming technology for next-generation cellular networks (5G)

  • To mitigate the interference caused while reusing frequency bands by the D2D pairs, investigation on the random resource allocation (RRA) method has been proposed in the literature [2]

  • We show that the performance of the system with more D2D pairs than cellular users achieved closer to the average target signal-to-interference-plus-noise ratio (SINR) compared to the communication scenario with less

Read more

Summary

Introduction

Device-to-device (D2D) communication underlaying long term evolution-advanced (LTE-A). Integrating D2D communications with traditional cellular networks can resolve the problem of available spectrum discovery and avoidance of collision between D2D pairs and cellular users [1]. In a D2D communication underlaying a cellular network, D2D pairs reuse the licensed cellular band to improve system spectrum efficiency, which leads to imminent interference between cellular users. To mitigate the interference caused while reusing frequency bands by the D2D pairs, investigation on the random resource allocation (RRA) method has been proposed in the literature [2]. FFR is radio resource partition method in the LTE-A system, which partitions the cell’s available band into different sections such that the users of the adjacent cell do not interfere with each other while reusing the cellular frequency by the D2D pairs [4].

Contribution
Related Works
Overview of Device-to-Device Communication
Network
Interference Analysis
Interference α
Outage Probability Analysis
System Throughput Optimization
Channel Model
Computational Complexity Analysis
Use Case Scenario of the Proposed Scheme
10. Performance Evaluation
10.1. Simulation Parameters and Values
10.2. Simulation Results and Discussions
Average targettarget
11. Conclusion
Full Text
Published version (Free)

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call