Nonlinear vibration response analysis of a rotor-blade system with blade-tip rubbing

Abstract

An improved rotor-blade dynamic model is developed based on our previous works (Ma et al. in J Sound Vib, 337:301–320, 2015; J Sound Vib 357:168–194, 2015). In the proposed model, the shaft is discretized using a finite element method and the effects of the swing of the rigid disk and stagger angles of the blades are considered. Furthermore, the mode shapes of rotor-blade systems can be obtained based on the proposed model. The proposed model is more accurate than our previous model, and it is also verified by comparing the natural frequencies obtained from the proposed model with those from the finite element model and published literature. By simplifying the casing as a two degrees of freedom model, the single- and four-blade rubbings are studied using numerical simulation and experiment. Results show that for both the single- and four-blade rubbings, amplitude amplification phenomena can be observed when the multiple frequencies of the rotational frequency \((f_\mathrm{r})\) coincide with the conical and torsional natural frequencies of the rotor-blade system, natural frequencies of the casing and the bending natural frequencies of the blades. In addition, for the four-blade rubbing, the blade passing frequency (BPF, \(4f_\mathrm{r})\) and its multiple frequency components also have larger amplitudes, especially, when they coincide with the natural frequencies of the rotor-blade system or casing; the four-blade rubbing levels are related to the rotor whirl, and the most severe rubbing happens on the blade located at the right end of the whirl orbit.