Nonlinear in-plane buckling of fixed shallow functionally graded graphene reinforced composite arches subjected to mechanical and thermal loading

Abstract

• Nonlinear in-plane buckling of FG- GPLRC arch subjected to uniform radial load and temperature field is investigated. • Analytical solutions for the limit point and bifurcation buckling loads are derived. • Parametric studies of different parameters on the nonlinear equilibrium path and buckling behavior are conducted. • Switches between limit point buckling, bifurcation buckling and no buckling are obtained and discussed. The nonlinear in-plane buckling analysis for fixed shallow functionally graded (FG) graphene reinforced composite arches which are subjected to uniform radial load and temperature field is presented in this paper. The arch is composed of multiple graphene platelet reinforced composite (GPLRC) layers with gradient changes of concentration of graphene platelets (GPLs) in each layer. The principle of virtual work, combined with the effective materials properties estimated by the Halpin-Tsai micromechanics model for GPLRC layer, is used to derive the nonlinear buckling equilibrium equations of the FG-GPLRC arch, and then the analytical solutions for the limit point and bifurcation buckling loads are obtained. Comprehensive parametric studies are conducted to explore the effects of various distribution patterns and geometries of GPL, temperature field and arch geometry on the nonlinear equilibrium path and buckling behavior of the composite arch. The influence of temperature on the geometric parameters which are defined as switches between limit point buckling, bifurcation buckling and no buckling are also discussed. It is found that a higher temperature field can increase the buckling loads of the FG-GPLRC arch but reduce the value of the minimum geometric parameters that switching the buckling modes. The results also show that even a small amount of GPLs filler content can increase the buckling loads of the FG-GPLRC arch considerably, and distributing more GPLs near the surface layers is the best pattern to enhance the buckling performances of FG-GPLRC arches.