Abstract
A solution for passive aeroelastic control is presented and tested experimentally on a bidimensional wing setup. The solution consists of a flap integrated in the wing which acts as a secondary mass damper and absorbs energy when aeroelastic instability is encountered. This device is passive, which makes it safe in emergency cases and adds little mass to the system in the fundamental case presented in this paper. If installed on actual aircraft wings, the flap-NES would not substitute but coexist with classic active control methods, adding virtually zero mass to the existing system. Using a flap placed in the airflow enables the control system to benefit from aerodynamic damping with a behavior dependent on wind speed. The device can either have a linear or nonlinear stiffness. It is shown that both options absorb energy from the main system, that is, the wing. The flap acts as a TMD (tuned mass damper) in the linear case and as an NES (nonlinear energy sink) in the nonlinear case. The nonlinear solution not only absorbs more energy at given wind speed but it also is a more suited solution as the damper follows the wind speed dependent frequencies due to its nonlinear feature. In this work, the flap-TMD and the flap-NES are tested experimentally on a bidimensional wing which presents classic flutter.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.