Abstract
Near-fault ground motions are characterized by long-duration horizontal pulses and high values of the peak vertical acceleration, which can become critical for a base-isolated structure. In order to check if current code provisions can be considered adequate for the design of base-isolated structures located in a near-fault area, base-isolated five-storey r.c. framed buildings with elastomeric bearings acting alone (“Base Isolation” system) or combined in parallel or in series with sliding bearings (“Base Isolation and in-Parallel Sliding”, BIPS, or “Base Isolation and in-Series Sliding”, BISS, systems) are studied. The base-isolated structures are designed assuming the same values for the fundamental vibration period and equivalent viscous damping in the horizontal direction. Different values of the stiffness ratio, defined as the ratio between the vertical and horizontal stiffness of the elastomeric bearings, are considered; moreover, different values of the sliding ratio, defined as the global sliding force corresponding to an examined BIPS or BISS system divided by the maximum sliding force (in the case of a sliding bearing under each column), are also assumed. The nonlinear analysis of the test structures subjected to strong near-fault ground motions is performed using a step-by-step procedure based on a twoparameter implicit integration scheme and an initial-stress-like iterative procedure. At each step of the analysis, plastic conditions are checked at the potential critical sections of the girders (i.e. end sections of the sub-elements in which a girder is discretized) and columns (i.e. end sections), where a bilinear moment-curvature law is adopted. The response of an elastomeric bearing is simulated by a model with variable stiffness properties in the horizontal and vertical directions, depending on the axial force and lateral deformation, and linear viscous damping. Finally, a rigid-plastic (with friction variability) law is assumed to simulate the behaviour of a sliding bearing.
Highlights
Different techniques aimed at enhancing the seismic performance of a structure through base-isolation [1,2,3,4,5,6,7] or energy dissipation [8,9,10,11,12] systems have been proposed in literature
In order to study the nonlinear dynamic response of the BI, Base Isolation with in Parallel Sliding (BIPS) and Base Isolation with in-Series Sliding (BISS) structures subjected to near-fault ground motions, a numerical investigation is carried out by using a step-by-step procedure [14, 18]
There may be some additional difficulties in the re-centring of a BISS system after an earthquake in case of out-of-phase movements between the isolators and the sliding bearings placed on them
Summary
Different techniques aimed at enhancing the seismic performance of a structure through base-isolation [1,2,3,4,5,6,7] or energy dissipation [8,9,10,11,12] systems have been proposed in literature. In the case of elastomeric bearings acting alone (“Base Isolation”, BI, systems) or combined in series with sliding bearings (“Base Isolation and in-Series Sliding”, BISS, systems), the structure behaves as isolated or fixed-base along. The Base Isolation with in Parallel Sliding (BIPS) systems are expected to behave as a fixed-base structure in the vertical direction, providing the grid of girders placed at the level of the isolation system with a high stiffness. In this case, the base-isolated structure behaves as a fixed-base structure in the horizontal direction until the friction threshold of the sliding bearings is not exceeded
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have