Abstract
In high-density packaging technology, one of the most important issues is the reliability of the microjoints connecting large scale integrated circuit chips to printed circuit boards electrically and mechanically. The development of nondestructive testing methods with high spatial resolution is expected to enhance reliability. An X-ray microtomography system called SP-μCT has been developed in Super Photon ring-8 GeV (SPring-8), the largest synchrotron radiation facility in Japan. In this work, SP-μCT was applied in the nondestructive evaluation of microstructure evolution, that is, the phase growth due to thermal cyclic loading in solder ball microjoints. Simulating solder microjoints used in a flip chip, specimens were fabricated by joining a Sn–Pb eutectic solder ball 100 μm in diameter to a steel pin in the usual reflow soldering process. The phase growth process was determined by observing the computed tomography (CT) images obtained consecutively at the fixed point of the target joining. In the reconstructed CT images, the distribution of the constituent phases in the Sn–Pb eutectic solder was identified based on the estimation value of the X-ray linear attenuation coefficient. Consequently, the microstructure images obtained nondestructively by SP-μCT provided us with the following useful information for evaluating the reliability of the solder microjoints. First, each phase involves not dispersing particles but a three-dimensional monolithic structure like a sponge. Second, the phase growth proceeds in such a way that the average phase size to the fourth power increases proportionally to the number of cycles. Finally, in the vicinity of the joining interface, more rapid phase growth occurs compared to the other regions because local thermal strain due to the mismatch of thermal expansion leads to a remarkable phase growth.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have