Abstract
In this paper, non-axisymmetric guided wave propagation in circular cylindrical, anisotropic structures is studied in a frequency range up to 1 MHz. The investigations are carried out with carbon fibre reinforced tubes. The aim is the experimental determination of their effective linear elastic material properties in a non-destructive way. Therefore, an analytical model of the dispersion equation is fitted to the experimentally detected dispersion curves by systematically adjusting the desired material properties. A total least square scheme accompanied by an outlier detection criterion is used for this optimization task. Since the raw data of the measured dispersion curves contain a lot of noise, these outliers have to be detected and excluded, to achieve accurate results. Good agreement is found between the measured curves and the analytically calculated curves based on the estimated parameters. This fact indicates a high accuracy of the determined material properties.
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a call
