Nondestructive characterization of bone tissue scaffolds for clinical scenarios

Abstract

ObjectivesThis study aimed to develop a simple and efficient numerical modeling approach for characterizing strain and total strain energy in bone scaffolds implanted in patient-specific anatomical sites. Materials and methodsA simplified homogenization technique was developed to substitute a detailed scaffold model with the same size and equivalent orthotropic material properties. The effectiveness of the proposed modeling approach was compared with two other common homogenization methods based on periodic boundary conditions and the Hills-energy theorem. Moreover, experimental digital image correlation (DIC) measurements of full-field surface strain were conducted to validate the numerical results. ResultsThe newly proposed simplified homogenization approach allowed for fairly accurate prediction of strain and total strain energy in tissue scaffolds implanted in a large femur mid-shaft bone defect subjected to a simulated in-vivo loading condition. The maximum discrepancy between the total strain energy obtained from the simplified homogenization approach and the one obtained from detailed porous scaffolds was 8.8%. Moreover, the proposed modeling technique could significantly reduce the computational cost (by about 300 times) required for simulating an in-vivo bone scaffolding scenario as the required degrees of freedom (DoF) was reduced from about 26 million for a detailed porous scaffold to only 90,000 for the homogenized solid counterpart in the analysis. ConclusionsThe simplified homogenization approach has been validated by correlation with the experimental DIC measurements. It is fairly efficient and comparable with some other common homogenization techniques in terms of accuracy. The proposed method is implicating to different clinical applications, such as the optimal selection of patient-specific fixation plates and screw system.