Non-Linear, Microscale Modelling of the Flow Over Askervein Hill

Abstract

The flow solver “3DWind” is used to explore new aspects of the Askervein hill flow case. Previous work has investigated sensitivities to the grid, the inflow boundary profile, the roughness and the turbulence model. Several different linear and non-linear numerical models have also been validated by means of the Askervein hill case. This analysis focuses on the flow sensitivity to the grid spacing, the incident wind direction and the vertical resolution of topographic data. The horizontal resolution is found to be fine enough to cause only minor differences compared to a grid where every second node is removed. The vertical resolution dependence is mainly attributed to the wall functions. Simulations are performed for wind directions 200°, 205°, 210° and 215° at the reference station. The smallest directional biases compared to experimental values along a line through the hilltop are found for the directions 200° and 205°. There are larger wind direction changes along this line through the hilltop in the 200° case than in the 215° case. Still the simulation results give less veering than found in the experimental results, and this is maybe caused by a slightly stable atmosphere. The sensitivity to the vertical resolution of the topographical data is found to be particularly high close to the ground at the top of the hill; this is where the speed-up is most important. Differences decrease with the height from the ground. At higher levels the speed-ups are smaller and caused by terrain formations with larger scales.