Non-Destructive Inspection Method Using Elastic Waves for Quality Management in the Bending Process Region of BFRTP

Abstract

In order to establish a sustainable infrastructure, structures must maintain their minimum required performance for an extended period. Typically, existing concrete structures are reinforced with steel, but the susceptibility of steel reinforcements to corrosion, attributed to factors such as carbonation and chlorides, can lead to performance degradation, rendering the specified requirements unmet. As a remedy, there has been a growing interest in using lightweight and corrosion-resistant fiber-reinforced polymer (FRP) bars as an alternative to traditional steel reinforcement in concrete structures. Particularly noteworthy is the use of FRP bars manufactured with thermoplastic resins (FRTP) due to their ease of processing and convenient applicability on construction sites. This study delves into the mechanical behavior evaluation by examining the propagation characteristics of elastic waves in the curved section of basalt FRTP (BFRTP). Multiple BFRTP bars underwent a 180-degree bending process, subject to various conditions, including heat and twist variations. Subsequent measurements focused on the propagation characteristics of elastic waves in the curved sections, emphasizing wave attenuation, frequency features, and propagation velocity. Additionally, bending tensile tests were conducted on the curved bars, and a comparative analysis was performed between the tensile strength and the aforementioned elastic wave propagation characteristics. The results affirm a consistent correlation between the propagation characteristics of elastic waves (amplitude ratio, centroid frequency, velocity) during the traversal of the curved BFRTP section and its tensile strength. Notably, both centroid frequency and velocity exhibited correlation coefficients exceeding 0.7, suggesting their potential efficacy as reliable indicators for estimating tensile strength.