Non-destructive evaluation of checking in thermally modified timber

Abstract

Non-destructive measurement techniques were used to study the characteristics of thermally modified timber (TMT), especially checking. Two non-destructive measurement techniques were evaluated: air-coupled ultrasound (ACU) and electrical impedance spectroscopy (EIS). In the studied TMT (N = 38), density and pith location in the cross-section were positively correlated with the number of checks in the cross-section. Several ultrasound signal features correlated with TMT characteristics, most strongly with number of checks. Severely checked samples and other samples were considered as two different classes of checking, and the potential of ultrasound for differentiating between the two classes was tested by using Bayesian classification method. The correct classification rate was 97 %. EIS parameters correlated with density and latewood content of TMT more strongly than the ACU parameters. Thus, for determination of checking and density or earlywood/latewood content, both EIS and ACU measurements are recommended.