Abstract
Multiple‐Input‐Multiple‐Output (MIMO) systems are widely used to enhance the system capacity in wireless communications systems. The complexity and the cost for implementing the multiple radio frequency‐chain (RF‐chain) increases proportional to the number of signal streams. Therefore, so‐called load modulating single‐RF MIMO system is one promising technology in the practical aspects. Load modulating single‐RF MIMO can utilize two‐port network for controlling the load and the desired signal can be generate by loading proper set of impedance. In this paper, the optimization method for choosing the two‐port network impedance solution that is robust to the impedance noise is proposed and the simulations are conducted to verify the robustness. © 2023 Institute of Electrical Engineers of Japan. Published by Wiley Periodicals LLC.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
More From: IEEJ Transactions on Electrical and Electronic Engineering
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.