Noise and thermal performance of a sub-attofarad capacitance sensor for precision measurements, with applications in gravitational wave detectors.

Abstract

Listen

Translate article

We describe the design principles, fabrication, and characterization of a precision AC resonant capacitance bridge (RCB) sensor, based on a resonant differential planar printed circuit board transformer with a solid (ungapped) MnZn ferrite core, demonstrating a short-term sensitivity at 293K of 0.225 ± 0.005 aF/√Hz at around 120kHz resonance frequency and 1Hz Fourier measurement frequency. At 120K, the RCB short term noise sensitivity is 0.118 ± 0.005 aF/√Hz. We compare the ungapped configuration to five different RCBs: three with a core gap of 65 μm and two with a core gap of 130 μm. Their average room temperature short term noise sensitivities are 0.30 ± 0.01 and 0.45 ± 0.01 aF/√Hz, while the cryogenic operation of these transformers at 120K resulted in averaged sensitivities of 0.23 ± 0.01 and 0.36 ± 0.01 aF/√Hz, respectively. Multi-hour room temperature runs, with one core of each of the three gap types, proved the stability of their long-term sensitivities of 0.234 ± 0.005, 0.338 ± 0.009, and 0.435 ± 0.010 aF/√Hz for the ungapped (40-h duration) and the 65 and 130 μm (28-h duration) cores, respectively. At 0.1mHz, a critical frequency for space gravitational wave detectors, the respective sensitivities are 0.25 ± 0.02, 0.35 ± 0.02, and 0.53 ± 0.07 aF/√Hz. Measurements with the ungapped transformer configuration for temperatures from 325 to 349K further validate the dependence of the noise model on temperature and permeability. The performance of our RCB with an ungapped core matches the calculated performance value and shows an improvement in signal-to-noise ratio of two or more compared with capacitance bridges developed for similar applications. A further factor of about two noise reductions is achieved by cooling to 120K.