Abstract
As digital imagers grow in pixel count and area, the ability to correct for pixel defects becomes more important. A fault tolerant active pixel sensor (APS) has previously been designed and fabricated that can correct for stuck high and stuck low defects. Analyses of the pixel noise for a standard APS and a fault tolerant APS are presented that consider reset noise, photocurrent shot noise, dark current shot noise, transistor thermal noise, transistor flicker noise, operational amplifier noise, and feedback resistor thermal noise. Under worst case conditions (no illumination), the noise of the fault tolerant APS is 1.106 /spl times/ more than a standard APS. At a typical illumination level, the fault tolerant APS noise is nearly unchanged to that of a standard APS. Previous research has shown that the fault tolerant APS is more sensitive than a standard APS, thus the overall signal-to-noise ratio of the fault tolerant APS should be greater than the standard APS except under very low light conditions.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.