No more rattling: biomechanical evaluation of a hexapod ring fixator free of play.

Abstract

Hexapod-ring-fixators have a characteristic rattling sound during load changes due to play in the hexapod struts. This play is perceived as unpleasant by patients and can lead to frame instability. Using slotted-ball-instead of universal-joints for the ring-strut connection could potentially resolve this problem. The purpose of the study was to clarify if the use of slotted-ball-joints reduces play and also fracture gap movement. A hexapod-fixator with slotted-ball-joints and aluminum struts (Ball-Al) was compared touniversal-joint-fixators with either aluminum (Uni Al) orsteel struts (Uni Steel). Six fixator frames each were loaded in tension, compression, torsion, bending and shear andmechanical performance was analyzed in terms of movement, stiffness and play. The slotted-ball-joint fixator wasthe only system without measurable axial play(<0.01mm) compared to Uni-Al (1.2±0.1)mm and Uni-Steel (0.6±0.2)mm (p≤0.001). In both shear directions the Uni-Al had the largest play (p≤0.014). The resulting axial fracture gap movements were similar for the two aluminum frames and up to 25% smaller for the steel frame, mainly due to the highest stiffness found for the Uni-Steel in allloading scenarios (p≤0.036). However, the Uni-Steel construct was also up to 29% (450g) heavier and had fewer usable mounting holes. In conclusion, the slotted-ball-joints of the Ball-Al fixator reduced play and minimized shear movement in the fracture while maintaining low weight of the construct. The heavier and stiffer Uni-Steel fixator compensates for existing play with a higher overall stiffness.