NMR Analysis of Lipid Oxidation in Flaxseed Oil-in-Water Emulsions.

Abstract

The formation of linolenic (Ln) and linoleic (L) acyl oxidation products during storage of flaxseed oil (FO)-in-water emulsions was monitored using proton nuclear magnetic resonance (1H NMR) spectroscopy, as well as chemical analytical methods and gas chromatography. Emulsions containing 10% FO and 1% Tween 60 were prepared by homogenization and then stored at 37 °C in the dark for 21 days under accelerated oxidation conditions (500 μmol ferrous sulfate). The induction time of the emulsions, after which rapid lipid oxidation was first observed, was 5-7 days, as shown by increases in peroxide values and hydroperoxide concentrations determined by NMR spectroscopy. Analysis of the hexanal and propanal concentrations during storage by HS-SPME-GC indicated that the oxidation of Ln and L acyls in the emulsions occurred simultaneously. The oxidation products originating from the Ln and L acyls were monitored using 1H NMR spectroscopy throughout the oxidation process. These results also showed that the Ln and L acyls oxidized simultaneously, and isomers of hydroperoxy-cyclic hydroperoxides (HCPs), Z,E-conjugated dienic hydroperoxides (ZECDHPs), and E,E-conjugated dienic hydroperoxides (EECDHPs) were the major primary oxidation products. Aldehydes were observed after 7 days, which was taken to be the start of the propagation stage, with the formation of a significant amount of oxygenated α, β-unsaturated aldehydes (OαβUAs). Based on the concentrations of hydroperoxides originating from the Ln and L acyls, our results suggested that the loss rate of L acyls was parallel to that of Ln acyls. This result was consistent with Ln acyls adopting a tighter packing at the oil-water interface in the emulsions than L acyls. This hypothesis was supported by the NMR relaxation time data. A good correlation between the isomer concentrations of ZECDHPs and HCPs in Ln acyls and between ZECDHPs and EECDHPs in L acyls was shown, with the mole ratios between them being 1.2 and 1.1, respectively. Droplet size and microstructure analyses showed that droplet aggregation occurred from 11 days onwards, which was attributed to polar oxidation products located at the oil droplet surfaces promoting coalescence. Zeta-potential measurements indicated that the droplets became more negative during storage, which was attributed to the accumulation of anionic reaction products at the droplet surfaces.