Abstract
The authors propose a simple, low cost, and mass producible imprint lithography method to texture indium tin oxide (ITO) contact layer of nitride-based light emitting diodes (LEDs). Under 20mA current injection, it was found that forward voltages were 3.24, 3.25, and 3.24V while the LED output powers were 11.7, 12.6, and 13.3mW for the conventional ITO LED, ITO LED patterned with 1.75μm holes, and ITO LED patterned with 0.85μm holes, respectively.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.