Nitric oxide reduction at noble metal electrodes: a voltammetric study in acid solution

Abstract

Features of the electrochemical reduction of nitric oxide on platinum, palladium, rhodium and ruthenium in aqueous perchloric acid solutions (0.33–1.0 M) are compared. The results from voltammetric studies ( ie linear potential sweep and rotating disc electrode) using the bulk metal electrodes are described and compared with residual current voltage plots in acid electrolyte alone. In general, three nitric oxide reduction peaks are observed on the metals. The most anodic peak, at ca E = 0.15 V vs sce is attributed to the one-electron reduction of nitric oxide to an adsorbed NOH intermediate on a bare metal surface ( ie one free of oxides or adsorbed hydrogen). The other two peaks occur in potential regions where adsorbed hydrogen is present on the metal surface ( ca E = 0.0 and −0.20 V, respectively). The co-adsorbed hydrogen complicates the analysis and precludes an unambiguous interpretation of these two peaks. However, they apparently reflect nitric oxide reduction to nitrogen, hydroxylamine and/or ammonia. In a cathodic scan on the rhodium electrode, a current plateau is seen instead of the first (most anodic) peak, a probable consequence of oxide film formation with subsequent chemical complications. On the ruthenium electrode the first two (most anodic) peaks are not observed probably due to a relatively stable oxide layer. Reaction selectivities at metal black gas diffusion cathodes operating in an electrogenerative ( ie galvanic) mode with perchloric acid electrolyte are compared with the voltammetric results at the corresponding bulk electrodes. Dinitrogen formation is observed on the platinum and rhodium black electrodes as suggested from voltammetric results. A series-parallel reaction sequence is proposed to explain the results. Limitations of using simple voltammetric techniques for predicting behavior of large scale preparative electrochemical reactors are discussed.