Abstract
Dimensional and surface quality for tile plate manufacturing control is facing difficult engineering challenges. One of these challenges being that plates in large-scale mass production contain geometrically uneven surfaces. There is a traditional measurement method used to assess the tile plate dimensions and surface quality based on standard specifications: ISO-10545-2: 1995, EOS-3168-2: 2007 and TIS 2398-2:2008. A new measurement method of the dimensions and surface quality for ceramic oblong large-scale tile plate has been developed compared to the traditional method. The strategy of the proposed method is based on CMM straightness measurement strategy instead of the centre point in the traditional method. Expanded uncertainties budgets in the measurements of each method have been estimated in detail. The capability of accurate estimations of real actual results of centre of curvature (CC), centre of edge (CE), warpage (W) and edge crack defects parameters has been achieved according to standards. Moreover, the obtained results showed not only a more accurate method but also improved the quality of tile plate products significantly.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
