New Concept of Co-Agents for Scorch Delay and Property Improvement in Peroxide Vulcanization

Abstract

Abstract Peroxide cure is an important and widely used cure system for rubber. Several properties obtained via peroxide vulcanization are superior and not achievable with sulfur vulcanization, e.g.: aging resistance, no reversion and low compression set. However, other properties such as tensile strength and dynamic properties, are inferior to those of sulfur vulcanizates. The use of co-agents in peroxide cure leads to a certain extent to improvement in mechanical properties such as tensile strength. Nevertheless the properties are still inferior with respect to mechanical/dynamical properties of sulfur-cured articles. If these properties can be improved, the range of applications of peroxide cure in the rubber industry can be significantly broadened. Scorch is a common problem in peroxide cure, especially for injection molding and extrusion applications. Several additives can help to improve scorch safety, however, they always result in a lower peroxide efficiency, thus inferior vulcanizate properties. In the present study a new concept of co-agents for peroxide vulcanization is introduced. This new concept consists of the use of a combination of a bismaleimide type co-agent, like N,N′-m-phenylenedimaleimide (BMI-MP), and a sulfur containing compound, like dipentamethylenethiuram tetrasulfide (DPTT). This combination provides scorch safety and at the same time improves the mechanical properties of the vulcanizates. Within the bismaleimide type co-agents N,N′-p-phenylenedimaleimide (BMI-PP) provides better mechanical properties than BMI-MP. The concentration of co-agent and sulfur containing compound have a big influence on the scorch time and on the mechanical properties. Optimal properties are reached with 4 phr of co-agent and 0.7 to 0.96 phr of sulfur containing compound.