Abstract
A multilayer (sputtered-sliced) Fresnel zone plate (FZP) is one of the promising focusing optics with high spatial resolution for the high-energy X-ray region. This is because a large “aspect ratio” can be realized easily. In addition, it is important that the kinoform FZP (theoretical diffraction efficiency=100%) can be fabricated by the sputtered-sliced method. This paper presents the experimental results of two new approaches for fabrication of a multilayer FZP for X-rays. (1) To achieve higher diffraction efficiency, a multilevel-type (4-step: quasi-kinoform type) FZP was fabricated. This FZP was composed of concentric multilayers of alternating high-Z, low-Z, and composite materials. The composite material layer was deposited by co-sputtering of high-Z and low-Z materials. (2) To achieve smoother zones (multilayer interfaces) at the conventional-type FZP, each target of a sputtering apparatus with two DC-sputtering guns was surrounded by a cover with an aperture, and Ar gas was supplied inside the cover, which led to the deposition at lower Ar gas pressure. As a result, for the former, the efficiency was improved markedly as compared with conventional FZP, and for the latter, the zone roughness was reduced, which has resulted in the improvement of the spatial resolution of the FZP.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.