Abstract
In this paper, a new approach for additive manufacturing metal-matrix composites based on Ti–6Al–4V titanium alloy reinforced with titanium carbide particles, as well as layered structures consisted of such composite and Ti–6Al–4V alloy layers is considered. The approach is based on 3D printing with a conical electron beam using a special cored wire, whose composition corresponds to metal-matrix composite. The issues of production such a wire, the features of the 3D printing process, when using it, as well as the features of formation of the microstructure and phase composition of the printed composite material are described. The issues of titanium-carbide particles’ wetting with Ti–6Al–4V melt during process of 3D printing, as well as possible thermogravitational effects (floating or drowning) for solid TiC particles within the melt are considered in detail with additional experiments. The influence of individual components of the wire composition on the formation of the microstructure and its uniformity over the cross section of the printed layer is shown. The possibility of controlling the formation of homogeneous structural state and obtaining sufficiently high values of the hardness (of above 600 HV) of the metal-matrix composite layer printed on the Ti–6Al–4V baseplate is shown.
Published Version
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
