Abstract
Fusion neutronics experiments are performed on a full-coverage blanket with various configurations of a beryllium neutron multiplier. In the basic experimental system, a lithium carbonate enclosure contains a lithium oxide test zone and a deuterium-tritium neutron source to simulate a neutron spectrum in a fusion reactor. Five beryllium configurations are adopted to examine the effects of neutron multiplication and reflection by beryllium. The measurements are carried out along the central line in the test zone. Various measurement techniques are applied to obtain the tritium production rate distribution, which is one of the most important parameters for assessing the total tritium breeding ratio in a fusion blanket. In addition, the reaction rates and the neutron spectrum are measured to provide test data for confirmation of calculation results. These data are compared among six different configurations of the experimental system. Consistency between the different techniques for each measured parameter is also tested among different experimental systems. The experimental results are compared with the calculations by DOT 3.5 using JENDL-3/PRI and /PR2. The calculation differs from the experimental data by <10%, except for the beryllium zone.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.