Abstract
In this study, the thermal stress alterations generated in a tungsten fiber reinforced titanium composite (W/Ti composite) were evaluated by the neutron stress measurement method at cryogenic temperatures. The W/Ti composite thermal loads were repeated from room temperature to the cryogenic temperature (10 K), and alterations in thermal residual stress were evaluated using the neutron in situ stress measurement method. In this measurement, the stress alterations in the titanium matrix and the tungsten fibers were measured. This measurement was carried out by TAKUMI (MLF-BL19) of J-PARC, a neutron research facility in the Japan Atomic Agency. The measurement method of TAKUMI is the time-of-flight (TOF) method. Owing to this measurement method, the measurement time was significantly shortened compared to the angle-dispersion type measurement by a diffractometer. As a result of the measurement, large compressive stresses of about 1 GPa were generated in the tungsten fibers, and tensile stresses of about 100 MPa existed in the titanium matrix. The thermal stresses due to the temperature change between room temperature and cryogenic temperature is caused by the difference of thermal expansions between the tungsten fibers and the titanium matrix, and these stress values can be approximated by a simple elastic theory equation.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.