Neural network based variable DC-link voltage control of electric vehicle driveline

Abstract

ABSTRACT The variable DC link direct torque control (DTC) for induction motors was proposed in this paper utilizing an artificial neural network (ANN). Variable DC-link voltage is utilized as the inverter’s controlling input to improve the induction motor’s performance. By injecting the dynamically variable dc-link voltage, inverter switching losses are decreased and inverter efficiency is increased. Two significant limitations are the torque ripple in DTC and the speed regulation of induction motors at low speeds. The driveline of an electric vehicle is modeled, and the suggested control is put into practice to enhance low-speed speed regulation, high dynamic performance, and minimal torque ripple. With variable DC-link voltage based on ANN, an improvement in torque and speed is made possible. Additionally, the suggested strategy minimizes the current ripples. To verify the improved efficacy of the electric driveline under various operating scenarios, a proposed control of the electric driveline is implemented using MATLAB SIMULINK, and the results are compared with the conventional scheme. The recommended speeds for the three speed ranges are as follows: 300 rpm for low speed, 900 rpm for medium speed, and 1275 rpm for high speed. The torque ripples decreased from 0.39 to 0.24 in the low-speed region, 0.38 to 0.24 in the medium-speed region, and 0.36 to 0.24 in the high-speed region while the motor was operated at a constant load torque of 2 N-m. The torque ripples decreased from 0.4 to 0.274 in the low speed region, 0.4 to 0.274 in the medium speed zone, and 0.2 to 0.274 in the medium speed region when the motor operated at various speed regions with a constant load. The main effect of running the motor at different load torques, such as 1.5 N-m, 2.5 N-m, and 2.0 N-m, is shown in Table 9 and numerical data of torque ripples is presented in Table 9.