Abstract
To determine the failing net out of a list of potential candidates provided by the ATPG diagnostic tool, probing techniques such as TRE or LVP are commonly used. To use these techniques, complex electrical setups using tester have to be implemented to control the failing net to its failing value. This paper present an alternative technique to check net integrity and to orient failure location based on optical techniques. Experimental results and simulation presented in this study demonstrate the relevance and the efficiency of this technique .
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
