Near-real time estimation of tsunami sources using a classification of waveforms observed at dense ocean bottom pressure sensor

Abstract

<p>A dense cabled observation network, called the seafloor observation network for earthquakes and tsunami along the Japan Trench (S-net), was installed in Japan. This study aimed to develop a near-real time tsunami source estimation technique using a simple classification of waveforms observed at the ocean bottom pressure sensors in S-net. To investigate the technique, synthetic pressure waveforms at those sensors were computed for 64 tsunami scenarios of large earthquakes with magnitude ranging between M8.0 and M8.8. The pressure waveforms within a time window of 500 s after an earthquake were classified into three types. Type 1 has the following pressure waveform characteristic: the pressure decreases and remains low; sensors exhibiting waveforms associated with Type 1 are located inside a co-seismic uplift area. The pressure waveform characteristic of Type 2 is that one up-pulse of a wave is within the time window; sensors exhibiting waveforms associated with Type 2 are located at the edge of the co-seismic uplift area. The other pressure waveforms are classified as Type 3.</p><p>Subsequently, we developed a method to estimate the uplift area using those three classifications of pressure waveforms at sensors in S-net and a method to estimate earthquake magnitude from the estimated uplift area using a regression line. We systematically applied those methods for two cases of previous large earthquakes: the 1952 Tokachi-oki earthquake (Mw8.2) and the 1968 Tokachi-oki earthquake (Mw8.1). The locations of the large computed uplift areas of the earthquakes were well defined by the estimated ones. The estimated magnitudes of the 1952 and 1968 Tokachi-oki earthquakes from the estimated uplift area were 8.2 and 7.9, respectively; they are consistent with the moment magnitudes derived from the source models. Those results indicate that the tsunami source estimation method developed in this study can be used for near-real time tsunami forecasts.</p><p>This method is so simple that we do not need any numerical tsunami simulation or other sophisticated techniques but only need the classification of observed pressure data into three types.</p>