Abstract
In this paper the capabilities of near-field and non-contact millimeter wave measurements for the purpose of accurately determining step and gap dimensions between two painted aircraft panels is demonstrated. Millimeter wave reflectometer with a single and a dual-differential open-ended rectangular waveguide probes were used in this investigation. It was shown that the dual-differential probe provides higher sensitivity than the single probe. A combination of a dual-differential and a single probe may be used to uniquely determine the step and gap dimensions from a combined set of output information.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.