Abstract
Cyclic deformation and fracture behavior of the 321 stainless steel are investigated at 633 K under engineering-stress and strain controlled low cycle fatigue (LCF) cycling, and the fatigue life data are compared with ASME section-III Division-1 S-N curve. In stress-controlled LCF tests, ratcheting-strain accumulation is observed even under zero mean-stress, and the direction of ratcheting is found to strongly depend on initial-ramp direction of first-cycle. In addition, plastic-strain range and striation width are observed to be higher than those in strain-controlled tests. The stress-life curve obtained from stress-controlled tests is 2–3 orders of magnitude lower in comparison to stress-life curve derived from strain-controlled LCF tests as per the ASME procedure. The discrepancy is attributed to the differences in deformation and damage development in stress and strain-controlled cycling.
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
