Abstract
This paper presents the numerical models for the estimation of temperature drop in a low temperature separator and pressure drop in a horizontal pipeline. As a basis for both models, the nume-rical models for flash calculations are fully taken into consideration. These models were applied to some field cases. The calculation results were compared with measured results, and reasonable agreement was observed. These models can be utilized for the selection of separator conditions to prevent the generation of hydrate and for the decision of an inside diameter of a horizontal pipeline in designing surface production facilities of natural gas.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callMore From: Journal of the Japanese Association for Petroleum Technology
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
