Natural and anthropogenic contamination of the Fratta-Gorzone river (Veneto, Italy)

Abstract

Stream-bed sediment samples were collected in 2001 and 2004 along the Fratta-Gorzone River (Italy) to assess the level of heavy metal contamination. The river stretch most affected by discharges of tannery effluent showed total and pseudo-total Cr levels (up to 2,860 mg/kg) that greatly exceed national and international chemical sediment quality standards. The most contaminated section of the river bed is located downstream of the main industrial discharge. However, a large fraction of the Cr present in the sediment appears to be of lithogenic origin. At most sites, more than 50% of Cr is not soluble in aqua-regia and thus unlikely to be very mobile or easily bio-available. A negligible risk to the benthic community can be inferred for Pb, Zn, Cd, Cu and Ni. This work highlights the limitation of using existing chemical sediment quality standards alone for risk assessment. The collection and analysis of suspended solids, the determination of river discharge and of dissolved Cr at 10 field stations allowed to estimate the particulate and dissolved Cr load and to locate the river stretch that was the likely source of contaminated sediment. The pumping of dilution water from the Adige River into the Fratta-Gorzone River did not produce the expected contaminant dilution effect due to re-suspension of contaminated solid particles and the release of Cr in solution.