Narrowing transient testing pulse widths to enhance LWR RIA experiment design in the TREAT facility

Abstract

The Transient Reactor Test (TREAT) Facility provided thousands of transient irradiations and plays a crucial role in nuclear-heated safety research. The facility’s flexible design and multi-mission nature saw historic experiments for numerous reactor fuels and transient types but was never specifically adapted to address very-brief pulse transients akin to postulated Light Water Reactor (LWR) Reactivity Initiated Accidents (RIA). Since the behaviors of fuel under these conditions depends strongly on energy input duration and resulting cladding time/temperature response under pellet cladding mechanical interactions, this three-year project was conceived to investigate new pulse-narrowing capabilities. Kinetic models showed incremental improvements for minor facility enhancements including increased reactivity step insertions (to initiate the power pulse) and slightly-increased transient rod drive speed for pulse termination (“clipping”). Replacing peak fuel assemblies, repositioning non-transient control rods to hold down the “hot side” of the core, and balancing against required excess reactivity needs, the limiting fuel assembly power can be reduced by ∼20%. This is a remarkable discovery of latent capability in TREAT, not only in enabling the subject capabilities for reduced pulse widths, but also significantly “uprating” the core’s transient energy capacity. Incremental improvements can likely enhance TREAT’s capability into BWR-relevant missions; briefer PWR pulse shapes can only be achieved with an advanced clipping system. Helium-3 (3He) was found to offer the greatest benefits for clipping design and overall performance. A unique concept showed great promise for enabling a 3He-based system with a reasonable cost; this design concept will likely become the focal point of future work.