Nanostructured thin film SrCo0.8Nb0.1Ta0.1O3-δ cathode for low-temperature solid oxide fuel cells

Abstract

Nanostructured perovskite-type cathodes are considered essential for the realization of high-performance solid oxide fuel cell (SOFC). However, perovskite-type cathode materials demonstrating high electrochemical performance in the low-temperature operating region below 600° are limited. SrCo0.8Nb0.1Ta0.1O3-δ (SCNT) has been identified as a material that exhibits exceptional performance even in the low-temperature region of 500 °C. This paper investigates the growth behavior and electrochemical properties of SCNT thin films for SOFC cathode applications. Pulsed laser deposition (PLD) was employed to fabricate SCNT films under varying chamber pressures: 5 mTorr, 75 mTorr, and 150 mTorr. Systematic analysis through X-ray diffraction and X-ray photoelectron spectroscopy indicates that the structural factors of PLD perovskite oxide nanostructures, such as grain size, porosity, and in-plane connectivity, are intricately influenced by deposition pressure without affecting crystallinity and chemical composition. The findings demonstrate that achieving desired electrochemical properties of the nanostructured PLD perovskite oxide necessitates specific optimal deposition conditions for these structural parameters. Electrochemical assessments revealed an optimal nanostructure achieved with 1200 nm at 75mTorr, demonstrating enhanced power density due to increased active reaction surface area, which significantly reduced resistances in ohmic and polarization. Excessive thickness, however, led to performance decline due to film delamination. Integration of optimized SCNT films into an anodic aluminum oxide supported thin film SOFC exhibited 907 mW/cm2 of peak power density at 550 °C.