Nanoscale ZrRGOCuFe layered double hydroxide composites for enhanced photocatalytic degradation of dye contaminant

Abstract

Coprecipitation method was used to prepare non-stoichiometric pristine copper and iron layered double hydroxide (LDH) doped with zirconium and embedded with reduced graphene oxide. The composite materials (ZrRGOCuFe LDHs) were studied for the photodegradation of methylene blue (MB) dye as a model contaminant from an aqueous solution. These composites were fully characterized by X-rays diffraction (XRD), Scanning electron microscopy (SEM), Energy Dispersive X-ray Spectroscopy (EDX), Fourier transform infrared spectroscopy (FTIR), Photoluminescence (PL), Raman spectroscopy and Electrochemical Impedance Spectroscopy (EIS). The results of Raman, Photoluminescence and Electrochemical Impedance Spectroscopy revealed the presence of oxygen defects level in the composites. Such defects are believed to be essential for boosting the catalytic potential of the composites. The secondary pollution manifested by transition metal ions is usually tackled by inducing heterogeneous catalysis. Herein, pristine CuFe LDH has been doped with Zr and RGO moieties to realize heterogeneous catalysis within ZrRGOCuFe LDH dopants. An admirable band ranging between 1.74 and 2.0 eV was obtained for the doped materials. The remarkable photodegradation efficiency of 95.2% was achieved by using heterogeneous photocatlyst Zr0.6RGOCuFe LDH within 75 min at a pH of 7 , photocatalyst dosage of 1.0 g/L and methylene blue dye solution of 10 ppm under visible light irradiation. The total organic content (TOC) analysis has revealed removal of 92% organic content. Moreover, the catalyst has the potentia to maitain sufficient stability and reusability capacity even after three successive cycles. The reaction kinetics and proposed photocatalytic mechanism were also explained in detail.