Abstract
Quasicrystalline aluminium alloys and aluminium based nanocomposites with the advantage of high strength over commercial aluminium alloys have been studied for many years. In this work a nanoquasicrystalline Al-Fe-Cr-Ti alloy powder and a nanocomposite consisting of a mixture of a nanoquasicrystalline alloy and nanosize γ-Al2O3 powders were produced through mechanical milling with different milling speeds. It has been observed that a higher milling time or milling speed can improve the homogeneity of the γ-Al2O3 distribution. The α-Al crystallite size decreases and the hardness increases with the milling time. The smallest crystallite size (14 nm) and the highest hardness value (638 HV10g) were obtained for the nanocomposite after 30 h of milling at 250 rpm. As the α-Al crystallite size is the main change in the microstructure during the ball milling process, the change in the hardness of the milled powders was found to follow a Hall-Petch type relation with an exponent of 0.25.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
