Nanophotonic color splitters for high-efficiency imaging

Abstract

SummaryStandard color imaging utilizes absorptive filter arrays to achieve spectral sensitivity. However, this leads to ∼2/3 of incident light being lost to filter absorption. Instead, splitting and redirecting light into spatially separated pixels avoids these absorptive losses. Herein we investigate the inverse design and performance of a new type of splitter which can be printed from a single material directly on top of a sensor surface and are compatible with 800 nm sensor pixels, thereby providing drop-in replacements for color filters. Two-dimensional structures with as few as four layers significantly improve fully color-corrected imaging performance over standard filters, with lower complexity. Being fully dielectric, these splitters additionally allow color-correction to be foregone, increasing the photon transmission efficiency to over 80%, even for sensors with fill-factors of 0.5. Performance further increases with fully 3D structures, improving light sensitivity in color-corrected imaging by a factor of 4 when compared to filters alone.