Abstract
This study investigated the influence of nanoparticle loading level on properties of experimental hybrid resin luting agents. Silanated 2-μm barium borosilicate glass microparticles and 7-nm silica nanoparticles were used. Five materials were obtained by loading a photocurable Bis-GMA/TEGDMA co-monomer with a total mass fraction of 60% inorganic fillers. The mass fraction of nanoparticles was set at 0% (control), 1% (G1), 2.5% (G2.5), 5% (G5), or 10% (G10). The properties evaluated were flexural strength (σ) and modulus (E(f) ), Knoop hardness number (KHN), and film thickness (FT). Dispersion/interaction of the particles with the resin phase was assessed by scanning electron microscopy (SEM). Data were submitted to statistical analysis (5%). For σ, G1 > G2.5 = G5 = G10, and control > G10. For E(f) , G2.5 > control = G1 > G5 > G10. For KHN, G5 = G10 > control = G1 = G2.5. For FT, G10 = G5 > control = G1, and G10 > G2.5. Incorporation of nanoparticles was associated with observation of clusters in the SEM analysis. The clusters were more frequent for higher nanoparticle loadings. Modest incorporation of nanoparticles may improve the properties of resin luting materials. Nanofiller mass fractions above 2.5% should, however, be avoided because they may be detrimental to the properties of the resin luting agents.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
