Abstract
The mechanism of cold-dwell fatigue of the Ti alloys Ti-6242S and IMI 834 was investigated by measuring their local strain-rate sensitivities using nanoindentation analysis, electron backscatter diffraction, and energy-dispersive X-ray spectroscopy. In addition, microcantilever bending tests involving a load-holding-induced change in plastic strain near grain boundaries were conducted to investigate the plastic behavior of the alloys. The difference in the strain-rate sensitivity exponent between soft and hard grains was large in Ti-6242S and small in IMI 834, although slips were generated in the hard grains of both IMI 834 and Ti-6242S by activated slips in the soft grains during the microcantilever bending tests. The hardness of IMI 834 varied with its Al concentration, whereas no Al-concentration-dependent changes in hardness were observed in Ti-6242S. These results suggest that the stress redistribution was caused by differences in the concentrations of solid elements and the crystal orientation of the hard and soft grains.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
