Abstract
AbstractDesign guidelines for optimizing the sensing performance of nanoimprinted second order distributed feedback dye lasers are presented. The guidelines are verified by experiments and simulations. The lasers, fabricated by UV‐nanoimprint lithography into Pyrromethene doped Ormocomp thin films on glass, have their sensor sensitivity enhanced by a factor of up to five via the evaporation of a titanium dioxide (TiO2) waveguiding layer. The influence of the TiO2 layer thickness on the device sensitivity is analyzed with a simple model that accurately predicts experimentally measured wavelength shifts induced by varied superstrate refractive indices. The superstrate refractive index is additionally shown to determine which of the possible waveguiding modes dominates for lasing, indicating a method to flexibly select the polarization of the laser. The detection limit of the sensor system is further discussed, finding an optimum at 7.5· 10−6 RIU. Wavelength changes caused by dye bleaching must be taken into account for long‐term measurements.
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
