Abstract
The aim of this study was to develop biocompatible lipid-based nanocarriers for retinyl palmitate (RP) to improve its skin delivery, photostability and biocompatibility, and to avoid undesirable topical side effects. RP loaded nanoemulsions (NEs), liposomes (LPs) and solid lipid nanoparticles (SLNs) were characterized in terms of size, surface electrical charge, pH, drug encapsulation efficiency and morphology. Spherical-shaped nanocarriers with a negatively charged surface (>|40|mV) and mean size lower than 275nm were produced with adequate skin compatibility. The rheological properties showed that aqueous dispersions of SLNs followed a non-Newtonian behavior, pseudoplastic fluid adjusted to Herschel–Bulkley equation, whereas LPs and NEs exhibited a Newtonian behavior. SLNs offered significantly better photoprotection than LPs and NEs for RP. The cumulative amount of drug permeated through human skin at the end of 38h was 6.67±1.58μg, 4.36±0.21μg and 3.64±0.28μg for NEs, LPs and SLNs, respectively. NEs flux was significantly higher than SLNs and LPs: NEs (0.37±0.12μg/h)>LPs (0.15±0.09μg/h)>SLNs (0.10±0.05μg/h). LPs offered significant higher skin retention than NEs and SLNs. Finally, even though all developed nanocarriers were found to be biocompatible, according to histological studies, NE was the system that most disrupted the skin. These encouraging findings can guide in proper selection of topical carriers among the diversity of available lipid-based nanocarriers, especially when a dermatologic or cosmetic purpose is desired.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have