Abstract
The formation of nanocrystalline structure in steels by ball milling, shot peening and drilling were studied. In ball milling and shot peening, nanocrystalline layers form with sharp boundaries from deformed structure regions. Nanocrystalline layer showed extremely high hardness. By annealing, nanocrystalline layer showed substantially slow grain growth without recrystallization. The temperature of the specimen during deformation is low and deformation is done in ferrite state. In drilling, several μm thick nanocrystalline layers form at the top surface of a drill hole. Nanocrystalline layers showed high hardness and good thermal stability. The fresh martensite and retained austenite near a drill hole indicate that the temperature reached above Ac3 and nanocrystalline layers are produced in austenite condition. It is recognized that nanocrystalline layers produced in the processes studied in the present investigation has similar characteristics irrespective of the temperature it produced. It is proposed that deformation with a large strain gradient is an important condition to produce nanocrystalline structure.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
