Abstract
In this study, we investigated the effect of wire strength on wire sweep after the semiconductor transfer molding assembly process. The wire sweep, loop height, and tensile strength of 25μm, 20μm, and 15μm diameter wires were measured. As the tensile strength of 25μm wires is higher, wire sweeps have a tendency to become smaller with 4.7 mm loops. However, such a trend is not shown in the case of 15μm wires. It is found that the wire sweep of 15μm wires depends on the loop height when the loop length is more than 4 mm, and it depends on the wire tensile strength when the loop length is less than 4 mm.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
More From: Journal of Japan Institute of Electronics Packaging
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.