Abstract
Magnetic abrasive polishing process experimentally tried to finish the mold surface. Magnetic abrasives are playing a very important role in this process. SiC whisker-Fe magnetic abrasive was newly fabricated by Mechanical Alloying (MA) method. This study ails to investigate the fabrication process of the MA magnetic abrasives and its finishing properties. SiC whisker-Fe magnetic abrasive by MA was superior to SIC powder-Fe, NbC powder-Fe, dia. ond-Fe or Al2O3 powder-Fe magnetic abrasives in its gringability.The as machined surface roughness value of 2.5, μm Rmax or 0.2μm Ra decreases to the finished value of 0.2μm Rmax or 0.06μm Ra respectively using 6.5 vol.% SIC whisker-Fe magnetic abrasive for 10hr of milling ti.e. Fabrication process of magnetic abrasive by MA will be hopeful for final finishing abrasives of magnetic polishing of mold surface. In order to obtain the higher efficiency magnetic abrasive, it is nesessary to investigate the influence of finishing conditions and other kinds of abrasives-Fe system magnetic abrasives in more detail.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
More From: Journal of the Japan Society of Powder and Powder Metallurgy
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.