Abstract
Excessive cutter wear was observed in tunneling with a TBM through the sandstone layers of the Mesozoic era in the Shimanto Belt. Generally, it causes not only the additional cost of cutter discs but also the additional time to replace them. The authors investigated the mechanical properties of rocks, quartz contents and shape of chips through the unconfined compression test, point load test and polarizing microscopic observation in order to clarify the relationships among the cutter wear and the geological properties. In conclusion, the excessive cutter wear was caused by the sandstone with high quartz contents and hard matrix. Additionally, it was found that the chip shapes were comparatively thin and wide in chippings through the hard rock which excessively wore cutter discs and the flatness was also higher with quartz contents.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
More From: Journal of the Society of Materials Science, Japan
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.